GreenBlast Wet Blast Technology
 GreenBlast Wet Blast Technology is a highly adaptable, flexible, safe and compact
system that offers nearly low media consumptions,
incomparable handling ease, exceptional cost savings, and
substantial environmental protection.
This technique allows us the flexibility to accommodate changes in a surface that's being cleaned/blasted, adjusting at will, to go from heavy blasting to gentle cleaning as the surface dictates. It does not matter what surface, Wet Abrasive Blast technologies distinguish themselves by perfect results on operations of all kinds with higher performance rates achieved.
|
| 1 ) | Environmentally Friendly and Good Visibility during Blasting |
| No Dust nor air pollution thus resulting in good visibility for blasters. Other work discipline can work side by side. |
| 2 ) | Economical Equipment Set-Up |
Specifically design for efficiency and low cost . |
| 3 ) | Low Media Consumption |
| Media consumption is controlled by “Differential Pressure Principle” and “Media Flow Orifice Size”. Estimated media consumption per m2 is between 8kgs to 12kgs. Higher for heavily corroded surfaces. |
| 4 ) | Low Water Consumption |
Wet Abrasive System requires water coming for a tank or tap. Requires only 1 liters per m2 for wet blasting.
|
| 5 ) | Low Pressure Requirement |
| Wet Abrasive System requires between 80 PSI and 100 PSI compressed air to perform the required surface preparation quality. |
| 6 ) | Safety |
Utilizing both air and water pressure at such a low output makes the working environment safe. The blasters can maneuver and handle the low pressure gun with ease to reach every corner.
|
| 7 ) | Hard to Reach Areas |
Hard to reach areas on a ship’s tanks are aplenty. Wet Abrasive System can reach all these areas with ease. No need for tedious hand power tooling to these areas at all.
|
| 8 ) | Tank Cleaning |
| With extremely low consumption of media, tank cleaning becomes easier. |
| 9 ) | Surface Preparation Quality |
Wet Abrasive System has the ability to blast to bare metal removing all corrosion scales and deep rust pitting. At the same time the blasted surfaces is washed off completely all salt and chloride contamination.  Flat Surfaces - 3.5mins /m2
Structures, Stiffeners, Angles - 7mins /m2 |
| 10 ) | Feathering and Sweeping Existing Coating |
Wet Abrasive System blasting has the ability to feather edges of the existing coating and by sweeping across the good existing coating, it cleans and creates a mild profile.
|
| 11 ) | Media Use |
For wet mode blasting the following media can be use on the Wet Abrasive System. a. Garnet b. Vissy Glass c. Sodium Bicarbonate d. Glass Beads ( Aluminum Substrate ) e. Walnut Shell ( Architectural Restoration ) f. Plastic Beads ( Aluminum / Wood ) |
| 12 ) | Cost Comparison |
a. Dry Grit Blasting : High b. Ultra Water Jetting : Extremely High c. Wet Abrasive System Blasting : Low
|
| 13 ) | Factors Taken into Consideration During the Design of Wet Abrasive System |
Safety in all Aspect, Productivity, Water Consumption, Media Consumption, Cost of Equipment, Cost of Service, Portability, Blasted Surface Quality, Environmental Impact, Applications |
| 14 ) | Ability to Blast Underwater |
| Jetty / Wharf Pipe Piles, Offshore Jacket Legs, Seawater Intake Structures, etc. |
| 15 ) | Blasters in Full Control |
 |